The 5.3 engine should have oil pressure between 40 and 60 PSI when it is at idle. If the oil pressure is lower than this, it could be an indication of a problem with the engine. If your 5.3-liter Chevrolet Silverado is idling and the oil pressure gauge reads between 20 and 40 pounds per […]

There is no definitive answer to this question as it depends on the make and model of the vehicle as well as the driver’s personal preferences. However, generally speaking, if the oil pressure gauge is reading above the middle of the range or above normal, then this may be indicative of too much oil pressure.

The amount of oil that a Cummins 6.7-liter engine can hold depends on the model of the engine. For example, the 2017 Ram 2500 with a Cummins 6.7-liter turbo diesel engine has a oil capacity of 15 quarts with filter. The Cummins 6.7 is a powerful engine that is used in many different types of

The 2015 Hyundai Elantra has a fuel capacity of 13.2 gallons and requires 5W-20 synthetic motor oil. With these specifications in mind, one can expect the Elantra to take approximately 2.6 quarts, or 64 ounces, of oil. The 2015 Hyundai Elantra takes 4.5 quarts of oil with a filter replacement. The first oil change should

Seadek is a marine product used to make nonskid surfaces on boats. It is made from a closed-cell EVA foam material and comes in sheet form. Seadek can be installed by the do-it-yourselfer, but installation by a qualified professional is recommended. Installation costs will vary depending on the size and complexity of the project, but

At a Cadillac dealership, an oil change for a SRX will typically cost between $70 and $120. This price will include the cost of both the oil and the filter, as well as any labor associated with changing them. If you choose to have your SRX’s oil changed at a non-dealership service center, the price

To change a cartridge oil filter, first unscrew the old filter using an oil filter wrench. Make sure to place a drain pan underneath the filter to catch any spilled oil. Next, remove the O-ring from the old filter and apply some new oil to it. This will make it easier to install the new

The Thunderbolt Ignition Module is a device that is installed in some vehicles that allows the engine to be started without the use of a key. This module can be bypassed by disconnecting the negative battery terminal and then connecting a jumper wire between the positive terminal and the starter solenoid. Open the hood of

There are a few ways that you can bypass the power window switch in your car. One way is to use a jumper wire to bypass the switch. Another way is to remove the switch and wire it directly to the battery. Locate the power window switch on the door panel Use a flathead screwdriver

The ignition control module is responsible for controlling the spark plug timing and firing the spark plugs. If your vehicle has an ignition control module, it is located near the coil pack or distributor. To bypass the ignition control module, you will need to disconnect the wiring harness that connects it to the coil pack