As long as the bell housing pattern is the same, a 454 can be bolted up to a 350 transmission. There may be some clearance issues with the block, so it is best to check fitment before attempting to install the engine. If you’re considering swapping out your 350 transmission for a 454, you might […]

No, a 4.3 bolt will not fit into a 2.2 transmission. The 4.3 is a much larger engine and will not physically fit into the smaller transmission. Additionally, the two engines use different types of transmissions so even if the 4.3 could physically fit into the 2.2 transmission, it would not work properly because they

If you have a 1500 Silverado and are looking to upgrade your front bumper, you may be wondering if a 2500 front bumper will fit. The answer is yes! A 2500 front bumper will fit a 1500 Silverado, although it may require some modification to do so.  A 2500 front bumper can potentially fit a

The 4WD light on a Ram 1500 indicates that the four-wheel drive system is engaged. If the light is illuminated, it means that the system is working properly. If the light is flashing, it indicates a problem with the system and should be checked by a qualified technician. Park your Ram on level ground and

When your computer is running low on memory, one way to clear up some space is by clearing the messages on your RAM. To do this, you can use the command line tool “ipcs” to view and remove interprocess communication structures. This will help to free up memory so that your computer can run more

To clear a historic fault code, you will need to use a diagnostic tool. Once you have the diagnostic tool, you will need to connect it to the vehicle’s on-board diagnostics port. After the connection is made, you will need to follow the prompts on the diagnostic tool to clear the code. Look up the

To clean spider injectors, remove the fuel injectors and disassemble them. Clean the injector body, nozzle, and screen with a brush and solvent. Reassemble the injector, being sure to lube the O-rings with petroleum jelly. Install the injectors and test for leaks. Remove the injector from the engine Disassemble the injector, being careful not to

To clean speedometer glass, start by mixing equal parts white vinegar and water in a bowl. Then, dip a microfiber cloth into the mixture and wring it out so it’s damp but not dripping. Next, gently wipe the cloth over the speedometer glass in a circular motion. If there are any stubborn spots, use a

If your plastic gas tank is old and has never been used, or if it has been sitting for a while, you will need to clean it out before using it. The easiest way to do this is to fill the tank with hot water and then let it sit for a few hours. This

Assuming you are talking about car rims, the best way to clean them is to first start with a dry microfiber cloth and wipe down the entire rim. If there are any stubborn dirt or brake dust buildups, use a small brush (toothbrush size) and lightly scrub the area. Once that is done, wet another