To test the PCM ground, you will need to use a multimeter. First, turn off your vehicle and disconnect the negative battery cable. Then locate the PCM ground connection and attach one lead of the multimeter to it. Make sure that your multimeter is set on ohms or resistance setting. If there is no reading […]
How to Test Pcm Ground Read More »
To replace struts without needing an alignment, you will need to mark the existing strut-to-knuckle bolts before removing them. When replacing the new struts, use a spring compressor tool and carefully compress the new springs until they fit into place in the knuckles. Once this is done, reattach the old marked strut-to-knuckle bolts with their
How to Replace Struts Without Needing Alignment Read More »
Yes, you can resurface drilled and slotted rotors. The process involves using a disc sander to smooth out the grooves and imperfections in the rotor surface. You will want to start with a coarse-grain sandpaper that is designed for metal surfaces and use it in an up-and-down motion over the entire surface of the rotor.
Can You Resurface Drilled And Slotted Rotors Read More »
Starting a Dodge Avenger without a key is possible, but it requires an additional piece of equipment called a “push-button start kit.” This kit includes all the necessary wiring and components for installing the starter system. First, you will need to disconnect the negative cable from your car battery. Then locate the ignition switch connector
How to Start a Dodge Avenger Without a Key Read More »
No, there is not a fuse for the tow haul button. The tow haul button is an electronic feature of some trucks that helps to increase engine braking when traveling downhill with heavier loads. It does this by increasing transmission line pressure and allowing the truck to shift into lower gears more quickly than it
Is There a Fuse for the Tow Haul Button Read More »
The parking brake, also known as the emergency brake or handbrake, is designed to keep a vehicle stationary when it is parked. When engaged, the parking brake automatically locks the rear brakes of your car so that it does not roll away on an incline. In most vehicles today, activating the parking brake involves pushing
Why Does My Parking Brake Automatically Engage Read More »
To test a coil pack wiring harness, first disconnect the negative battery cable. This will prevent any accidental electrical shocks or sparks from occurring during the testing process. Next, locate the coil pack and remove its wiring harness. Using an ohmmeter, measure the resistance between each terminal of the connector to ensure that all wires
How to Test Coil Pack Wiring Harness Read More »
To get the Subaru out of brake maintenance mode, begin by turning off the ignition and depressing the brake pedal for approximately three seconds. Then, turn the key to position two (between on and off). Press down on both accelerator and brake pedals at the same time until you hear a chime. Finally, release both
How to Get Subaru Out of Brake Maintenance Mode Read More »
No, you cannot drive with a bad IWE. The Integrated Wheel End (IWE) is an important component of the four-wheel drive system in many vehicles. It helps transfer power from the transmission to the wheels, which enables them to rotate and turn as necessary for driving. When this component becomes worn or damaged it can
Can You Drive With a Bad Iwe Read More »
Yes, bad tires can cause the ABS light to come on. The reason for this is that when tires are worn down, they become less effective and lose traction more easily. This can lead to problems with the Anti-lock Braking System (ABS) of your car. When the wheels begin to slip or skid, it triggers
Can Bad Tires Cause Abs Light to Come on Read More »
