Pinstripes are decorative lines of paint that can be applied to automobiles, motorcycles and other vehicles. To remove painted pinstripes without damaging the underlying paint, use a heat gun or hair dryer to soften the adhesive used to hold them in place. Once softened, carefully scrape away with a plastic razor blade or putty knife. […]

Yes, Pedal Commander is worth it. It helps improve the overall performance of the vehicle by allowing you to adjust the throttle response. It can help increase acceleration and torque while decreasing turbo lag time and fuel consumption. Additionally, it gives you complete control over your car’s throttle settings so that you can customize your

A timing chain should have the correct amount of slack. Too much slack can cause noise and vibration, while too little slack can cause a timing chain to stretch or break from excessive tension. Generally, a timing chain should have between 0.2-0.4 inches of play when you pull it away from the sprocket teeth at

To erase the memory of a key fob, first locate the reset button on the device. The reset button may be located inside or underneath its cover or battery compartment. Once you have located the reset button, press and hold it for about 10-20 seconds until you hear a beep or see an LED light

Yes, you can use 93 octane in a generator. The octane rating of gasoline is measured on a scale of 87 to 93 and higher, with the higher numbers indicating better resistance to pre-ignition or knocking when fuel is burned. Generators typically require at least 87 octane gas, but some may recommend using premium grade

To bypass the ignition switch, first locate the starter relay. This is usually a small black box located underneath the dashboard near the steering column. Then disconnect the wires that are connected to it and move them so they are no longer touching each other. Once this is done, you can use a wire to

1. To unstick ABS valves, you will need some basic materials such as a brake bleeder wrench, compressed air source with pressure regulator, and a vacuum pump. 2. Start by removing the wheel assembly that contains the stuck valve and then locate the bleed port on the back of it. 3. Connect your brake bleeder

If you’re driving a Ford Edge and notice the ABS light illuminated on your dashboard, it’s essential to address it promptly. The ABS (Anti-lock Braking System) is a critical component of your vehicle’s safety system, preventing wheel lockup during sudden stops. While the ABS light might signal a minor issue, ignoring it could lead to