To remove an alternator pulley, you will need to use a flathead screwdriver and a socket wrench. Start by disconnecting the negative terminal of the battery. Then, locate the two bolts that hold on the alternator pulley. Make sure to loosen both at the same time in order to keep tension off of the drive […]

Yes, an anti-theft light can drain a car battery. The purpose of the anti-theft light is to act as a deterrent to potential thieves by having the lights on when the vehicle is parked and not in use. This means that if your car has been sitting for an extended period of time with its

1. Before attempting to remove the stuck valve cover, be sure to wear safety goggles and protective gloves for your own safety. 2. Place a rag on top of the valve cover so that any dirt or debris that comes off during removal doesn’t get into the engine area. 3. Spray penetrating oil around the

Removing a bypass on an alarm system is not difficult, but it does require knowledge of the specific type of system you have. In general, to remove a bypass from an alarm panel, you will need to locate the “Bypass” switch or button on the control panel. Depending on your system type and model, this

Yes, it is possible to bore a 5.3 liter engine block to 6.0 liters. This process involves the machining out of the existing cylinder walls and increasing the diameter of the cylinders and then honing them back down in order for them to accept oversized pistons from an aftermarket supplier such as Wiseco or CP

50X4 Watts means that the wattage of a certain device is 200 watts. This means that it requires 200 watts of power in order to operate properly. This number is usually found on the back or bottom of an appliance, and it will tell you how much energy the device uses when turned on. A

The amount of torque required to remove a crankshaft bolt depends on the size and type of bolt being removed. Generally, for most automotive engines, bolts are tightened with between 24 ft./lbs. and 36 ft./lbs. of torque; however, some specialty engines may require higher or lower levels of torque depending on their design. To ensure

To bypass a headlight ballast, you will need to locate the wiring harness going from the battery to the headlight and cut it. Then separate one of the wires coming from each side of the harness and connect them together. This should create a direct connection between your battery and your headlights, bypassing any sort

To bypass a 3 wire coolant level sensor, the first step is to disconnect the power source to the vehicle. Next, locate and remove the three-wire connector from its mounting point near the coolant reservoir. The wiring harness will typically include a black ground wire, a red power wire and an orange signal wire. Cut