To bypass the neutral safety switch, you will need to locate the wiring harness that connects to the switch and find a way to bridge or short out pins on it. The easiest way is by using a wire jumper with alligator clips on each end. You can then clip one end of the jumper […]

Limp mode is a safety feature designed to protect your engine and transmission in the event of a malfunction. To bypass limp mode on a BMW, you need to first find out what caused the limp mode condition so you can address it properly. If nothing appears to be wrong, then resetting the fault codes

Replacing rod bearings can be a costly endeavor, depending on the make and model of your vehicle. For most cars, it will cost anywhere from $200 to $600 for labor alone. The cost of parts such as bearings, bolts, gaskets, washers and sleeve sets can range from around $25 up to around $100 or more

To diagnose 4X4 problems, first you should check the condition of all four tires. If one tire is significantly more worn than the others, this could be a sign that there’s an issue with your 4X4 system. Next, inspect your drive-shafts and U-joints for signs of damage or wear. Then check to make sure that

1. Check the seatbelt for any visible damage, such as fraying or tears. If there is any damage, replace the seatbelt before attempting to release it. 2. Look at both ends of the seatbelt and make sure they are properly connected in the buckle mechanism; if not, connect them so that you can proceed with

When a car battery is changed, the radio will not work until it has been reset. This is due to the fact that when the battery power is cut off, the radio’s memory settings are lost and must be reprogrammed. To reset the radio, you need to enter an unlock code which can usually be

1. Begin by placing a drain pan underneath the oil filter to catch any spilled oil. 2. Locate the oil filter using your vehicle’s service manual and identify which tools you’ll need to remove it. Depending on the model, you may need a wrench or an adjustable pliers with extensions for hard-to-reach filters. 3. Put

The reason why your car AC only works in the morning is likely due to low refrigerant levels. The refrigerant level in your system can become low over time due to a slow leak or damage caused by wear and tear. Low levels of refrigerant cause the air conditioner’s compressor to work harder, resulting in

To remove the speed limiter on a car, begin by getting an ECU tuning box. This device will be connected to the engine control unit (ECU) and allow you to adjust certain settings in order to maximize performance. After connecting it, use the software that came with it to access its settings and disable or

The cost of getting rims painted black will depend on a few factors, such as the size, type, and condition of the rim. Generally speaking, you can expect to pay anywhere from $30-$200 per wheel (or less) for basic black powder coating. If you are looking for a custom paint job or specialty finishes such