Car Problems Solution

First, unscrew the two screws that are holding the console in place at the front Then, pull the console up and out of the Jeep Finally, disconnect any wiring that may be attached to the console and remove it from the Jeep completely HOW TO TAKE REMOVE OR TAKE A PART CENTER CONSOLE JK JEEP […]

To remove a broken tensioner pulley bolt, If the tensioner pulley bolt is broken, you will need to remove it before you can replace the tensioner Here are a few steps to remove a broken tensioner pulley bolt: 1 Use a ratchet and socket to loosen the nut that secures the pulley to the bolt

The GMC Acadia computer can be reset by disconnecting the battery for about 30 seconds. This will cause the computer to forget any stored codes and revert back to its default settings. Locate the fuse box in your GMC Acadia This is usually located under the hood, on the driver’s side near the firewall Find

If you have a broken fuse prong in your car, you can remove it by following these steps:  Start by disconnecting the battery This will ensure that you don’t accidentally electrocute yourself while working on the fuse box Once the battery is disconnected, locate the broken fuse prong and gently remove it from the fuse

To reset the computer on your Ford Taurus, you will need to disconnect the battery for at least 30 seconds. This will allow the computer to reset itself and should clear any codes that may be causing your problems. If you are still having issues after resetting the computer, you may need to take it

If you have a flat tire on your Infiniti Qx50, the first thing you need to do is reset the flat tire warning. Here’s how: Park your Infiniti Qx50 in a safe place and turn off the engine Locate the flat tire pressure sensor, which is located on the driver’s side door pillar Use a

If your Chevy HHR’s engine starts acting up, you may need to reset the ESC. Here’s how: 1. Turn the ignition to the “Off” position and wait 3 seconds. 2. Press and hold the gas pedal for 5 seconds. 3. Start the engine and drive at a moderate speed for 10 minutes. 4. Repeat steps

If your Dodge Avenger is experiencing electrical issues, you may need to reset the power module. To do this, First, open the hood and disconnect the negative battery cable Next, locate the fuse box and remove the fuse for the ECM Once the fuse is removed, use a test light to check if there is

To reset the distance to empty on your Nissan, simply press and hold the reset button on your instrument cluster for about 5 seconds. The display will then show “—” to indicate that the system has been reset. Open the driver’s side door and locate the fuse box Find the fuse labeled “ECU” and remove

Assuming you have a Mercedes C-Class convertible: 1. Park the car on level ground and set the parking brake. 2. Open the trunk and locate the control unit for the top. It will be on the left side near the hinge that opens the trunk. 3. Press and hold the reset button for 5 seconds.