Car Problems Solution

Assuming you would like to bypass your headlight switch in order to have your headlights stay on: 1. Locate your headlight switch and disconnect the harness. 2. Find the wire that is supplying power to your headlight switch and splice it into the wire that is going to your headlights. Open up the headlight switch […]

One way to bypass the crank position sensor is to disconnect the battery. This will cause the engine to stall and the check engine light will come on. Another way to bypass the sensor is to remove the positive battery cable. This will also cause the engine to stall and the check engine light will

If your car’s air conditioner isn’t working, one possible cause is a failed compressor clutch. If the clutch is not engages, the compressor can’t pump refrigerant. There are a few ways to check whether or not the clutch is engaging. One way is to listen for a click when you turn on the AC. If

There are many ways to bulletproof a 5.3 Vortec engine. Some common methods include upgrading the fuel system, installing a better cooling system, and upgrading the engine internals. Choose a reliable 5 3 Vortec engine Inspect the engine for any damage or wear and tear If necessary, replace any damaged or worn out parts with

Building a Chevy 302 is a fun and rewarding process that can be done by anyone with basic mechanical skills. The first step is to gather all of the necessary parts and tools, including a block, crankshaft, connecting rods, pistons, cylinder heads, gaskets, and bolts. Next, the block needs to be cleaned and inspected for

Building a boat bench seat is a simple project that can be completed in a weekend with basic woodworking tools and materials. The most important factor in determining the success of the project is to take accurate measurements and cut the pieces to fit together snugly. Start by cutting the two side panels and the

A Baja Bug is a Volkswagen Beetle modified to excel in off-road racing. The original Baja Bug was created in 1968 for use in the Mexican 1000 race, now known as the Baja 1000, and they remain popular in desert racing today. While there are many ways to build a Baja Bug, there are a

There are a few different ways to bleed trim and tilt mercruiser. The most common way is to use the manual override valve. This is usually located on the side of the power steering pump. Other ways include using a vacuum bleeder or pressure bleeder. Whichever method you use, be sure to follow the instructions

The process of bleeding a NV3500 clutch is relatively simple, but will require another person to help you. Park the vehicle on a level surface and engage the emergency brake. Place a drain pan underneath the transmission’s drain plug and remove it. With the drain plug removed, allow all of the fluid to drain out

To bleed your 2010 Camaro V6’s cooling system, open the radiator cap and fill the radiator with a 50/50 mixture of coolant and distilled water. Next, start the engine and let it run until it reaches operating temperature. With the engine still running, use a turkey baster to draw out any air pockets in the