If your Chevrolet Cruze needs a service theft deterrent system reset, here’s how to do it. The first thing you need to do is find the fuse box. On most Cruzes, it’s located on the driver’s side, near the knee.
Once you’ve found the fuse box, open it up and locate the “Service Theft Deterrent” fuse. This should be a 10 amp fuse. Remove this fuse for about 10 seconds before putting it back in.
This will reset your service theft deterrent system and allow you to continue with your scheduled maintenance.
- Open the hood and locate the fuse box
- Find the “Service” fuse and remove it
- Close the hood and wait 30 seconds for the system to reset itself
- Start the car and test to see if the issue has been resolved
Service Theft Deterrent System Chevrolet Cruze 2012 Car it worked
How to Fix Service Theft Deterrent System Chevy Cruze
If your Service Theft Deterrent System Chevy Cruze is giving you trouble, there are a few things you can do to try and fix the issue. First, check all the fuses in the system. If any of them are blown, replace them and see if that solves the problem.
Next, check the battery. If it’s low on power, charge it up or replace it. Finally, check all the connections in the system to make sure they’re tight and free of corrosion.
If none of these solutions solve the problem, then you may need to take your car to a dealership or mechanic for further diagnosis.
Credit: www.reddit.com
How Do I Get My Chevy Cruze Out of Anti-Theft Mode?
If your Chevy Cruze is in anti-theft mode, there are a few things you can do to try and get it out. First, check to see if the battery is disconnected or low. If so, connect or charge the battery and then try starting the car.
If that doesn’t work, there may be an issue with the starter or ignition switch. Try having someone else turn the key while you hold down the unlock button on the remote. If that doesn’t work, you’ll likely need to take it to a dealership or mechanic to have them diagnose and fix the problem.
How Do You Reset a Chevy Theft Deterrent?
If your Chevy has a theft deterrent system, you may need to reset it at some point. Here’s how to do it: First, find the valet key.
This is usually a small, black key that is different from your regular car keys. If you can’t find it, check your owner’s manual. Next, insert the valet key into the ignition and turn it to the “On” position.
Don’t start the car – just leave it in the “On” position. After about 10 minutes, turn off the ignition and remove the key. Your Chevy’s theft deterrent system should now be reset!
How Do You Get the Service Theft Deterrent System Off?
If your vehicle has the Service Theft Deterrent System (VTD), you can disable it by doing the following:
1. Locate the VTD control module. On GM vehicles, this is usually under the dash on the driver’s side.
2. Disconnect the battery negative cable and wait for at least 30 seconds. This will reset the system and allow you to re-enable it if desired.
3. Remove the VTD fuse from the fuse block.
This will permanently disable the system.
What Does It Mean Service Theft Deterrent System?
A service theft deterrent system is a security measure that is designed to deter and/or detect attempts to steal services. This can include measures such as CCTV, alarms, door locks, and others. The goal of these systems is to make it more difficult and/or risky for would-be thieves to successfully steal services, thus deterring them from attempting to do so.
In some cases, these systems may also be able to alert authorities in the event of an attempted theft, allowing for a quicker response time.
