To reset the average mpg on your Silverado, simply press and hold the trip/fuel button for more than 2 seconds. The display will then show “—” to indicate that the averages have been reset.
- Open the Silverado’s hood and disconnect the negative battery cable using a wrench
- Locate the computer module, which is usually located behind the kick panel on the driver’s side of the vehicle
- Unplug the module’s connector and remove any retaining bolts holding it in place with a socket wrench
- Remove the old module and install a new one in its place, then reconnect the connector and reattach any bolts that were removed
- Reconnect the negative battery cable and close the hood
How to reset trip computer on a 2019 Chevy Silverado
What Does Resetting Mpg Do
If you’re looking to improve your car’s fuel economy, resetting your mpg display can be a helpful first step. By starting with a clean slate, you can more accurately track your progress and identify any improvements you may be making. Here’s a quick guide on how to reset your mpg display:
1. Start with a full tank of gas. This will ensure that you have accurate readings from the start. 2. Reset the trip odometer.
This will be different depending on your car – consult your owner’s manual if you’re unsure how to do this. 3. Drive as usual and keep track of your mileage over time. Try to avoid sudden acceleration or braking, as this can impact your mpg readings.
4. After a week or so, check back in on your mpg display to see what kind of progress you’ve made!
Credit: www.reddit.com
How Do You Reset the Fuel Economy on a 2022 Silverado?
It’s easy to reset the fuel economy on your 2022 Silverado. Just follow these simple steps: 1. Turn the ignition to the “On” position without starting the engine.
2. Press and hold the trip odometer button for about five seconds. 3. The display should now read “—-”, indicating that the fuel economy has been reset. 4. Start the engine and begin driving!
How Do I Reset My Gas Mileage?
Assuming you would like tips on resetting your car’s gas mileage: One way to reset your gas mileage is to simply fill up your tank and reset the trip odometer. This will give you a fresh start and hopefully help improve your gas mileage.
Another tip is to avoid idling as much as possible. Idling can use up a lot of fuel, so try to turn off your engine whenever you can. Finally, keep your tires inflated to the proper pressure levels.
This will help with fuel efficiency and overall performance.
Why am I Not Getting the Right Mpg?
There are a number of reasons why you might not be getting the right mpg. Here are some things to check: 1. First, check your car’s owner’s manual.
It should list the manufacturer’s suggested fuel economy for your specific vehicle model. Compare this number to your actual mileage to see if there’s a discrepancy. 2. Make sure you’re using the right type of gas for your car.
Some cars require premium gas while others run just fine on regular unleaded gasoline. Check your owner’s manual or look for a sticker inside the gas cap area that indicates which kind of gas to use. 3. Inspect your tires’ air pressure levels monthly and keep them inflated to the manufacturer’s recommended psi levels.
Having low tire pressure can negatively affect fuel economy by up to 3%. 4. Avoid excessive idling since it wastes fuel needlessly. If you’re going to be stopped for more than 30 seconds, it’s better to turn off your engine until you’re ready to move again rather than letting it idle away unnecessarily.
5.”Doing” extra things with your car like carrying around heavy loads or pulling a trailer also reduces mpg because the engine has to work harder when hauling extra weight around town or on the highway.
How Do You Reset the Odometer on a Chevy Silverado?
If you need to reset the odometer on your Chevy Silverado, there are a few different ways that you can do it. One way is to disconnect the battery for a few minutes and then reconnect it. This will cause the odometer to reset back to 0 miles.
Another way is to remove the instrument cluster fuse for a few minutes and then replace it. This will also reset the odometer back to 0 miles. If neither of these methods work, you may need to take your vehicle to a dealership or mechanic and have them reset the odometer for you.
Conclusion
It’s easy to reset the average MPG on your Silverado. Just follow these simple steps:
1. Fill up your gas tank and reset the trip odometer.
2. Drive until the fuel light comes on.
3. Note the number of miles driven and divide by the number of gallons used. This will give you your average MPG for that fill-up.
4. Repeat steps 1-3 until you have at least 3 data points to work with, then take the average of those numbers to get your overall average MPG for your Silverado.
