There are a few different ways that you can disable the speed limiter on your Ram 1500. One way is to disconnect the battery for a few minutes and then reconnect it. This will reset the computer and allow you to change the settings.
Another way is to use a programmer or chip to override the factory settings. Finally, you can also install a larger throttle body which will increase the amount of air that flows into the engine and allow you to go faster.
- Open the hood and locate the vehicle’s throttle body
- Unplug the electrical connector from the throttle body
- Remove the two bolts that hold the throttle body to the intake manifold using a wrench or socket set
- Lift the throttle body off of the intake manifold and set it aside
- Locate the speed limiter module, which is mounted on top of the transmission case near the back of the engine compartment
- Unplug the electrical connector from the speed limiter module
- 7 Use a wrench or socket set to remove the two bolts that holdthe module in place, then lift it off and set it aside
2022 Ram 1500 Speed Limiter Removal
As the owner of a Ram 1500, you may have noticed that your truck’s speed is limited to 80 miles per hour. This is because Ram has placed a speed limiter on all of their trucks in order to comply with federal regulations. However, there is a way to remove this speed limiter so that you can enjoy the full power and performance of your truck.
Here’s how:
The first step is to locate the speed limiter module. This is usually located in the engine bay near the ECU.
Once you’ve found it, disconnect the negative battery terminal to avoid any electrical shorts.
Next, remove the two screws that hold the module in place and carefully unplug it from its harness. Now take a look at the back of the module where you’ll see three jumpers labeled “A,” “B,” and “C.”
Using a sharp knife or wire cutter, carefully remove jumper “A” from its position.
Now it’s time to reassemble everything and test it out! Reconnect the negative battery terminal and start up your truck.
You should now be able to drive at speeds above 80 miles per hour without any issue. Enjoy!
Credit: www.buyacar.co.uk
How Do I Turn off Speed Limit Exceeded on Dodge Ram 1500?
If you’re driving a Dodge Ram 1500 and you get a speed limit exceeded warning, there are a few things you can do to turn it off. First, try slowing down to the posted speed limit. If that doesn’t work, you can try turning off the cruise control feature.
To do this, press the cancel button on the steering wheel until the cruise control light goes off. If neither of these methods works, then your best bet is to contact a Dodge dealer or service center for help.
Can You Turn off the Electronic Speed Limiter?
Most electronic speed limiters can be turned off by the driver. However, some vehicles have electronic speed limiters that cannot be turned off. If you’re not sure if your vehicle has an electronic speed limiter, check the owner’s manual or ask a dealer.
Do Ram Trucks Have a Speed Limiter?
Yes, Ram trucks come with a speed limiter. The speed limit is set at 80 km/h (50 mph). If you exceed this speed, the truck will automatically slow down to the preset limit.
Can I Take the Speed Limiter off My Truck?
Yes, you can take the speed limiter off your truck. However, we do not recommend doing so. The speed limit is in place for a reason – to keep you and other drivers safe on the road.
By removing the speed limiter, you are putting yourself and others at risk. If you must remove the speed limiter, be sure to drive safely and always obey the posted speed limits.
Conclusion
If you’re looking to disable your speed limiter on your Ram 1500, there are a few things you’ll need to do. First, find the fuse box and locate the fuse for the speed limiter. Once you’ve found it, remove the fuse and start your truck.
You should now be able to drive without any speed limit! Just be sure to drive safely and obey all traffic laws.
