To strap down a dirt bike, you will need: – Two Ratchet Straps (or one long one) – A way to secure the front of the bike (for example, a sand anchor or a tree stump) 1. Park the bike on level ground and put it in gear. 2. Run the strap under the seat […]
How to Strap down a Dirt Bike Read More »
If you need to stick something on your car dashboard, the best way to do it is with a suction cup. First, make sure that the surface of the dash is clean and free of any dirt or debris. Then, take the suction cup and press it firmly against the surface. If the suction cup
How to Stick Something on Car Dashboard Read More »
If your Scion tc is equipped with an automatic transmission, press and hold the brake pedal before inserting the key into the ignition. If you have a manual transmission, place the shifter in neutral before inserting the key. Once the key is inserted, turn it to the “on” position without starting the engine. This will
How to Start Scion Tc Without Key Read More »
If your mower has run out of gas, you’ll need to add more before you can start it again. To do this, first make sure that the mower is turned off and the spark plug is disconnected. Then, remove the cap from the gas tank and use a funnel to pour in fresh gasoline. Once
How to Start Mower After Running Out of Gas Read More »
In order to set the timing on a 5.7 Vortec without a scanner, you will need to disconnect the negative battery cable, remove the distributor cap, rotate the engine until the number one piston is at top dead center, and then reconnect the negative battery cable. Once you have done this, you can proceed to
How to Set Timing on 5.7 Vortec Without Scanner Read More »
Assuming you have a 4.3L Vortec engine, the firing order is 1-6-5-4-3-2. The distributor should be at the back of the engine on the driver’s side. There are two bolts that hold down the distributor cap. Find the rotor (it’s under the cap) and line it up with the mark on the distributor body that
How to Set Timing on 4.3 Vortec Read More »
The 4.3 TBI (Throttle Body Injection) system uses a computer to control the amount of fuel that is injected into the engine. The timing of the injection is controlled by the computer and can be adjusted to match the needs of the engine. The timing can be set to meet the requirements of different types
How to Set Timing on 4.3 Tbi Read More »
If your 1998 5.7 Vortec isn’t running properly, it may be due to the timing being off. Luckily, you can fix this problem at home with a few tools and some patience. First, remove the distributor cap and rotor. Next, locate the timing mark on the crankshaft pulley and align it with the 0 mark
How to Set the Timing on a 1998 5.7 Vortec Read More »
There are two ways to set the clock on your 2014 Chevy Silverado. The first way is by using the buttons on the radio. Press and hold the “Menu” button until the radio displays “Settings.” Use the arrow buttons to scroll to “Clock,” then press and hold the “Set/Reset” button until the clock begins blinking.
How to Set the Clock on a 2014 Chevy Silverado Read More »
To set the clock on a 2011 Honda Civic, press and hold the CLOCK button until the numbers start flashing. Use the SEEK/SKIP buttons to adjust the hours and minutes. Press and release the CLOCK button to set the time. Open the driver’s side door and locate the instrument panel on the left side of
How to Set the Clock on a 2011 Honda Civic Read More »
