Car Problems Solution

The mfr body code is typically located on the vehicle’s door jamb or on a placard inside the engine compartment. If you’re looking for the manufacturer’s body code on your vehicle, there are a few places you can look. The first is the door jamb. There will usually be a sticker on the inside of […]

If your car seat is in need of a good cleaning, there are a few options for where to get it shampooed. Many car washes offer this service, and most do a great job. You can also take it to an upholstery or carpet cleaner. Both types of businesses usually have the necessary equipment to

The ground wire on a car battery should be connected to the frame of the vehicle. This will provide a good ground connection and help prevent corrosion. Most cars have a 12-volt battery. The heart of the electrical system, this battery provides power to start the engine and run accessories like the headlights, radio and

The transmission dipstick is located on the driver’s side of the vehicle, just behind the engine. It is a long, thin metal rod with a handle on one end and a small cup on the other. The cup is used to catch a small amount of transmission fluid so that it can be checked for

The Vsc button on a Lexus RX 350 is located on the center console, to the left of the shifter. If you’re looking for the Vsc button on a Lexus RX 350, it’s located on the center console. The Vsc button is used to turn on and off the vehicle stability control system. This system

Assuming you would like tips on resetting the ABS light on a Dodge Ram 2500: One way to reset the ABS light on your Dodge Ram 2500 is to disconnect the battery. This will cause the light to turn off. You can also try unplugging the ABS sensor which is located near the wheel. Another

To replace the fuel injectors in a Dodge Ram 1500, first disconnect the negative battery cable. Then remove the intake manifold cover and disconnect the fuel lines from the injectors. Next, remove the electrical connectors from the injectors and unscrew the bolts holding the injectors in place. Pull out the old injectors and insert new

To reset the ABS light on a Chevy Impala, first turn the ignition to the “On” position without starting the engine. Next, press and release the brake pedal three times. Finally, turn the ignition off and then back on again. The ABS light should now be reset. Start the Chevy Impala and let it idle

A fuel pressure regulator is a device that controls the amount of fuel that is delivered to the engine. The fuel pressure regulator is located between the fuel pump and the carburetor. It is usually mounted on the firewall or fender well. The fuel pressure regulator regulates the fuel pressure by allowing more or less

Use a floor jack to support the lower control arm. Remove the bolt that secures the torsion bar to the lower control arm. Use a pry bar to remove the torsion bar from the lower control arm. Loosen the lower control arm bolt with a ratchet and socket Raise the lower control arm with a