In order to fix a Northstar engine oil leak, it is important to first identify the source of the leak. This can be done by inspecting the area around the…
Yes, you can reuse tire sensors. Tire sensors are small electronic devices that measure the pressure and temperature of a vehicle's tires. They provide drivers with important information about the…
To calibrate a brake pedal position sensor, you will need to adjust the switch located on the brake pedal arm so that it is in the correct position. First, make…
Yes, a bad rear end can cause transmission problems. When the rear end is not in good condition, it will generate vibrations and uneven loads that can be transmitted to…
In order to properly grease suspension, you will need a few tools such as an adjustable wrench, a spray bottle of lubricant or grease, and a rag. First you'll need…
Yes, a transfer case control module needs to be programmed. This is because the software inside the control module must be configured and calibrated to match the specific components used…
Anti Rattle Clips are used to eliminate the noise caused by loose suspension components. They go between a component and its mounting bracket or frame member. Anti rattle clips can…
The power steering light coming on typically means that the system has detected a problem with either the power steering fluid, pressure, or system. It can be caused by low…
The torque spec for brake caliper bolts is typically between 15 and 20 Newton-meters, or 11 to 14 foot-pounds. Different vehicles may have different requirements depending on the make, model,…
Tire Pressure Monitoring System (TPMS) calibration typically takes between 20 and 40 minutes to complete. The time it takes to calibrate the TPMS will depend on the make and model…