Posts by Skeet Dugazon

To remove an alternator pulley, you will need to use a flathead screwdriver and a socket wrench. Start by disconnecting the negative terminal of the battery. Then, locate the two…

Yes, an anti-theft light can drain a car battery. The purpose of the anti-theft light is to act as a deterrent to potential thieves by having the lights on when…

1. Before attempting to remove the stuck valve cover, be sure to wear safety goggles and protective gloves for your own safety. 2. Place a rag on top of the…

Removing a bypass on an alarm system is not difficult, but it does require knowledge of the specific type of system you have. In general, to remove a bypass from…

Yes, it is possible to bore a 5.3 liter engine block to 6.0 liters. This process involves the machining out of the existing cylinder walls and increasing the diameter of…

50X4 Watts means that the wattage of a certain device is 200 watts. This means that it requires 200 watts of power in order to operate properly. This number is…

The amount of torque required to remove a crankshaft bolt depends on the size and type of bolt being removed. Generally, for most automotive engines, bolts are tightened with between…

To bypass a headlight ballast, you will need to locate the wiring harness going from the battery to the headlight and cut it. Then separate one of the wires coming…

To bypass a 3 wire coolant level sensor, the first step is to disconnect the power source to the vehicle. Next, locate and remove the three-wire connector from its mounting…