In order to fix a Northstar engine oil leak, it is important to first identify the source of the leak. This can be done by inspecting the area around the engine and any components that may have come loose or are leaking. Once identified, you should replace any worn or damaged parts such as gaskets, […]
How to Fix Northstar Engine Oil Leak Read More »
Yes, you can reuse tire sensors. Tire sensors are small electronic devices that measure the pressure and temperature of a vehicle’s tires. They provide drivers with important information about the condition of their tires and help them maintain safe driving conditions. Reusing tire sensors is possible as long as they are not damaged or malfunctioning
Can You Reuse Tire Sensors Read More »
To calibrate a brake pedal position sensor, you will need to adjust the switch located on the brake pedal arm so that it is in the correct position. First, make sure that the switch is not too close or too far away from the brake light contact. Then, use an adjustable wrench to loosen and
How to Calibrate Brake Pedal Position Sensor Read More »
Yes, a bad rear end can cause transmission problems. When the rear end is not in good condition, it will generate vibrations and uneven loads that can be transmitted to the drivetrain. This extra strain can lead to transmission issues such as worn bearings, leaking seals, cracked components or even complete failure of the transmission.
Can a Bad Rear End Cause Transmission Problems Read More »
In order to properly grease suspension, you will need a few tools such as an adjustable wrench, a spray bottle of lubricant or grease, and a rag. First you’ll need to locate the suspension points which are typically found near the wheel hubs. Once located, use your adjustable wrench to loosen each nut that is
How to Grease Suspension Read More »
Yes, a transfer case control module needs to be programmed. This is because the software inside the control module must be configured and calibrated to match the specific components used in your vehicle’s drivetrain. It is important that this programming process is done correctly, as it ensures that all of the components will work together
Does a Transfer Case Control Module Need to Be Programmed Read More »
Anti Rattle Clips are used to eliminate the noise caused by loose suspension components. They go between a component and its mounting bracket or frame member. Anti rattle clips can be found on many vehicles in various forms such as rubber grommets, metal clips, or spring steel bars and straps. Common locations for these clips
Where Do Anti Rattle Clips Go Read More »
The power steering light coming on typically means that the system has detected a problem with either the power steering fluid, pressure, or system. It can be caused by low levels of fluid due to a leak in the system, dirty or contaminated fluids, air trapped in the lines, a faulty pump or motor assembly,
What Causes Power Steering Light to Come on Read More »
The torque spec for brake caliper bolts is typically between 15 and 20 Newton-meters, or 11 to 14 foot-pounds. Different vehicles may have different requirements depending on the make, model, and year of the car. It is always important to double check with a qualified mechanic or reference manual before attempting any repairs. When tightening
What is the Torque Spec for Brake Caliper Bolts Read More »
Tire Pressure Monitoring System (TPMS) calibration typically takes between 20 and 40 minutes to complete. The time it takes to calibrate the TPMS will depend on the make and model of your vehicle, as well as the type of service being performed. During calibration, each wheel sensor is tested for accuracy and adjusted if necessary.
How Long Does Tpms Calibration Take Read More »
